EMC Pre-Compliance Test
EMC test is a far-field testing, which gives frequency information about which frequency points are overstandard, but there is no location information. Near-field measurement sits very convenientally for interference positioning, and even accurate to the IC pin to specific line, thus determining the cause of interference.
The test is designed for the measurement of conduction interference below 30 MHz. For the power terminal conduction interference, it mainly measures the interference voltage emitted by the device under test (DUT) to the power supply network along the power cord. It can also measure the interference signal that travels through the signal line and transmits to other surrounding equipment
Conduction Pre-Compliance Test
Expanded Capabilities Within RSA Series Spectrum Analyzer
Built-in CISPR bandwidths and detectors
Automated scans of multiple segments
Limit lines and automated peak/limit searches
Up to 3 traces with different detectors
Log frequencies into the signal table
Real-time measurements with 3 detectors at marker or signal
Corrections for antennas, LISNs, cables, and preamps
Recommended Solution
• Model: RSA5000/RSA3000/DSA800 Spectrum Analyzers
• Near-field probe: NFP-3
• Built-in EMI Pre-compliance Software: RSA5000-EMI/RSA3000-EMI
• EMI Pre-compliance PC Software: S1210
• Quasi-peak detector/EMC filter: RSA5000-EMC/RSA300-EMC/EMI-DSA800
